Detroit-radiant-products-company FA Series Instrukcja Użytkownika

Improper installation, adjustment, alteration, service or maintenance can cause property damage, serious injury or death. Read and understand the inst

10FA SeriesChart 2.2 • Standard and Code Installation Guidelines • Building LocationChart 2.3 • Standard and Code Installation Guidelines • Building A

11FA SeriesClearance to CombustiblesClearance to combustibles is defined as the minimum distance that must exist between the specified feature of the he

12FA SeriesHigh humidity or saltwater atmospheres will accelerate heater corrosion and reduce useful life. Do not install the heater in locations wher

13FA SeriesRecommended Mounting HeightsChart 3.1 • Recommended Mounting Heights** Recommended mounting heights are provided as a guideline. Actual co

14FA SeriesGas Supply Installation InstructionsThe gas supply to the unit heater must be connected and tested in accordance with national, state, prov

15FA SeriesChart 3.2 • Natural Gas Consumption*Assumes an average heating value of 1050 BTU/SCF and a Specific Gravity of 0.60.Chart 3.3 • Propane Gas

16FA SeriesChart 3.4 • Maximum capacity for Schedule 40 Metallic pipe, in CFHThe FA Series heater is equipped to receive a gas supply line nipple of e

17FA SeriesLeak TestingAlways leak test final gas assembly for gas leaks according to the procedures outlined in NFPA 54 and all local codes and/or Sta

18FA SeriesElectrical Requirements and Wiring DiagramsAll field installed wiring to the unit heater must be done in accordance with national, state, pr

19FA SeriesField Wiring Supply VoltageBefore proceeding with electrical connections, ensure that the supply voltage, frequency, phase and current capa

2FA SeriesContentsTable of Contents1.0 Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

20FA SeriesFigure 3.3 • Field WiringConnect wires together with UL approved wire connectors.Green to GroundBlack to L1White to L2Note: A UL Listed swi

21FA SeriesThermostat ConnectionNOTE: Different thermostats operate according to their particular features. Refer to the thermostat’s specifications fo

22FA SeriesThermostat LocationThe location of the thermostat should be determined by the desired heating requirements and be mounted on an inside wall

23FA SeriesVentingThe FA Series unit heater must be vented as described here to properly direct the flue gases from the unit to the outside atmosphere.

24FA SeriesGeneral Venting RequirementsThe venting system for the FA Series heaters may terminate horizontally through a sidewall or vertically throug

25FA SeriesFigure 3.5 • General Vent RequirementsWhen possible, avoid venting through an unconditioned space. Venting through an unconditioned space p

26FA Series3.0 Installation • Vertical Venting (Category I) • Vent Locations and Clearances Vertical Venting (Category I)An appliance that operates wi

27FA Series3.0 Installation • Rooftop Venting • Horizontal Venting (Category III)Figure 3.6 • Rooftop Venting - Side ViewHorizontal Venting (Category

28FA SeriesVent Locations and Clearances:• Category III venting systems may NOT be common vented, and no other gas units are allowed to be vented int

29FA Series3.0 Installation • Common Venting (Category I) • Common Rooftop VentingCommon Venting (Category I)The common vent system and all attached a

3FA SeriesOverviewThe intent of this manual is to provide information regarding safety, design guidelines, installation, operation and maintenance of

30FA Series3.0 Installation • Concentric Venting • Combustion Air RequirementsConcentric VentingContact the factory for concentric venting requirement

31FA SeriesSeparated Combustion SystemsAll FA Series heaters come with a factory-installed combustion air adapter for attaching air intake ducts to th

32Figure 3.9 • Outside Combustion Air Sidewall Intake - Side View3.0 Installation • Separated Combustion SystemsFigure 3.10 • Outside Combustion Air V

33FA Series3.0 Installation • Room Air Combustion SystemsRoom Air Combustion SystemsWhen operating this unit as a room air combustion appliance, the f

34FA SeriesUnit Start-Up (Commissioning)Pre-Start Up ChecksVerify that the installation conforms to all of the specifications of the manual, as well as

35FA SeriesVerify Proper Inlet PressureBefore starting up the unit, smell all around the unit heater for gas. Be sure to smell next to the floor becaus

36FA Series13 Remove the pressure gauge tube and the 1/8 inch NPT hose connector.14 Replace the inlet pressure tap plug on the gas control valve.15 L

37FA Series8 While waiting for the unit to stabilize, observe the characteristics of the flame. The flame should be stable and should not lift for

38FA SeriesHigh Altitude OperationThe FA Series heater is factory configured for altitudes from 0 – 2,000 ft above sea level. If the unit heater is bei

39FA SeriesChart 3.6 • High Altitude Conversion Kits for Elevations of 4,501 to 7,000 FeetChart 3.7 • High Altitude Conversion Kits for Elevations of

4FA SeriesInitial Installation Considerations and Pre-ChecksPlacement of the heater is influenced by many factors. Aside from safety factors, considera

40FA Series4.0 Operation • Sequence of Operation4.0 OperationWARNING!This appliance does not have a pilot ignition. It is equipped with an ignition d

41FA SeriesShutdown Procedures: Set the thermostat to the lowest setting.Turn OFF all electrical power to the appliance if service is to be perfor

42FA Series4.0 Troubleshooting Guide4.0 Troubleshooting GuideTurn on control device for heat.Does the draft inducer motor turn on?NoYesLimit switch is

43FA SeriesBypassing any switch is intended for testing purposes only. Do not leave switch bypassed during normal operation or the heater’s built-in

44FA Series4.0 Troubleshooting GuideDo the burners ignite?YesContinued from page 42.Do the burners stay lit?YesDoes the air motor fan turn on approx.

45FA Series4.0 Troubleshooting GuideWere the gas lines purged of all air?Does the heater’s gas type match the gas supplied?YesCheck manifold pressure.

46FA Series5.0 MaintenanceTo check gas tightness of the safety shut off valves, turn off the manual valve upstream of the appliance combination contro

47FA Series5.0 Maintenance9 Check lubrication instructions on motor. If oiling is required, add three or four drops of SAE 20 electric motor oil:

48FA Series5.0 Maintenance • Heater Components and Parts ListFA Series Cabinet 3 (FA-100 & FA-125) Parts ListingFigure 5.1 • Heater Assembly Compo

49FA Series5.0 Maintenance • Heater Components and Parts ListChart 5.1 • FA Series Cabinet 3 (FA-100 & FA-125) Parts ListPart No. Description Par

5FA SeriesProduct SpecificationsThe FA Series unit heater is a single input warm air heater with an average thermal efficiency of 80%, unless otherwise

50FA SeriesFA Series Cabinet 4 (FA-150, FA-175 & FA-200) Parts ListingFigure 5.2 • Heater Assembly Components5.0 Maintenance • Heater Components a

51FA SeriesChart 5.2 • FA Series Cabinet 4 (FA-150, FA-175 & FA-200) Parts ListPart No. Description Part No. DescriptionCKP_ 5 4 _ 6 Propane Con

52FA SeriesFA Series Cabinet 5 (FA-225 & FA-250) Parts ListingFigure 5.3 • Heater Assembly Components5831,5.0 Maintenance • Heater Components and

53FA SeriesChart 5.3 • FA Series Cabinet 5 (FA-225 & FA-250) Parts ListPart No. Description Part No. DescriptionCKP_ 5 4 _ 9 Propane Conversion

54FA SeriesDate Maintenance Performed Replacement Parts RequiredMaintenance Log 5.0 Maintenance • Maintenance Log

55FA Series5.0 Maintenance • Limited WarrantyLimited Warranty Terms and ConditionsOne-Year Limited Warranty. The heaters covered in this manual are wa

56FA Series5.0 Maintenance • Kit Contents Check ListChart 5.4 • Kit Contents for FA SeriesLLUH008Room Air Clearance LabelKit Contents Check ListFA Se

6FA Series1.0 Introduction • Safety Labels and Their LocationsSafety Labels and Their LocationsProduct safety signs or labels should be replaced by th

7FA Series1.0 Introduction • Safety Labels and Their LocationsService Access Door View (Inside View) F/N: LLWUH001 - Wiring DiagramF/N: LLUHCL001 For

8FA SeriesRead and understand all safety information and warnings in this manual prior to installation, operation, and maintenance of this unit heater

9FA SeriesStandards, Certifications and Government RegulationsInstallation of this gas-fired heater must conform with all applicable local, state and na